Secure the straps to the downspout using screws.
#A b connectors aluminum gutter install
Install the fitted downspout in its place and fold both ends of the mounting straps over it. If required, use wooden spacers, cut from two-by-four pieces of lumber and attach aluminum mounting straps on them and secure them with screws to the wall through the wood. Find Aluminum Gutters in Services Find or advertise local services in Ontario : cleaning, fitness, IT, photography, storage, moving, massage and more on Kijiji, Canadas 1 Local Classifieds.
Join and secure the next elbow to direct the main downspout close to the walls. Give a slope to this piece of downspout, so that the water will flow through it easily. The downspout should get near the walls of the house. Kaycan Gutter Side Square Elbow - White - Aluminum - 1 Per Pack - 2-in L x 3-in W is rated 4.5 out of 5 by 14. After cutting, fit the downspout pieces, between the elbows, and screw them. The downspout pipes are tapered at one end, so whenever you cut them, cut from the non-tapered end. Use a hacksaw to cut the downspout to the desired length. Place another elbow at the next point where you need it and measure the distance between both the elbows, adding a few more inches to the length of the pipe. Step 4 – Directing the Downspout Close to the Walls Secure the elbow to the connector with self-tapping screws. Step 3 – Attaching the ElbowĪttach an elbow to the connector with the crimped end, pointing toward the house. For a more secure grip, drill in using screws. Use our Location Finder to see what product brands are available at an ABC Supply store near you. The manufacturers listed above are not available at all locations. Place the connector in the square space that was cut away from the gutter, and press it down to seal. ABC Supply is a wholesale distributor of aluminum rainware, aluminum rain gutters, gutter coil, aluminum downspouts, gutter guards and aluminum gutter accessories. Place silicone sealant around the lip of the downspout connector. Punch holes in each corner of the square and then cut away the piece, using a jigsaw or snips. Cut a square hole in that place, making a template out of the sleeve used for attaching the downspout. Mark the place where the downspout should be fitted in the gutter.
0 kommentar(er)
